 |
AirgunAdvice.net
All airguns, All the time
|
| Support Our Site |
click image to see designs
 |
Support the site by buying one of our great T-Shirts !!
They are only $24.95 plus shipping.
|
| View previous topic :: View next topic |
| Author |
Message |
Tedio
Marksman
Joined: 23 Jul 2010
Posts: 11
City, State: Nazareth, PA
|
 Posted: Sat Jul 24, 2010 2:37 pm Post subject: Newbie Question about Cylinder Oil |
 |
|
Hello,
I was just wondering where all the "sweet spots" are for applying cylinder oil on RWS 6M. It says not to apply to compression chamber. Thanks again, Ted |
|
| Back to top |
|
 |
Ca_Varminter
Site Admin
Joined: 17 Apr 2005
Posts: 4133
City, State: N. California, USA
|
| Posted: Sat Jul 24, 2010 3:05 pm Post subject: |
|
|
Adding anything to the compression chamber is a definite No-No! 
RWS did make a "compression chamber" lube, but it still was a bad idea!
The volume of air being compressed ,
then exiting transfer port at extreme velocity... acts just like diesel engine!! So a springer will diesel when excessive lube is present!!
Only time a lube is used... Is when you rebuild it. After you put your new piston seal, you put a thin smear of High content Molybdenum Disulfide grease behind the "Lip" of the seal...
Stuart
_________________
 |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
FAQ
Search
Memberlist
Usergroups
Phoogle Map
Register
Profile
Log in to check your private messages
Log in
